Areas we serve · Tri-Valley · Danville
Replacement windows and patio doors in Danville.
Pergo Systems replaces windows and patio doors in Danville homes, measured and planned at your home by a specialist; there is no showroom. In Danville every window replacement needs a building permit, so the proposal you get from us says who applies for it.
Homes from around 1980, mostly owner-occupied
More than eight homes in ten in Danville are owner-occupied (US Census, 2020–2024), and only about one home in thirty dates from 2010 or later; the median home was built around 1980.
Heat and fire, both checked per address
Danville is in the state's energy-code climate zone 12 (California Energy Commission); Livermore airport, the nearest long-record station, averages about 11 days a year at 100 °F or more (NOAA normals, 1991–2020). Heat-blocking glass is the first choice on the west side. We look up your parcel on the state's fire-hazard map before anything is specified.
The permit in Danville
The Town of Danville requires a building permit for any replacement, alteration or addition of a window, applied for online as a Window/Door/Skylight Replacement. That includes a same-size insert in the existing frame, which is different from nearby Pleasanton. Source: Town of Danville, Window Replacement handout (rev. January 28, 2026), checked November 15, 2026.
What we replace
Sliding, single-hung, casement, awning and picture windows, set in the existing frame or with the frame replaced. Sliding patio doors. For a wider opening onto the yard, folding and multi-slide glass doors. One door, a few windows or the whole house.
For a large picture window we check the size limits of the glass and how it will be carried in before we promise a single piece.
How it goes
- A free visit at your home: we look at every opening, the frames, the trim and the wall around them, and how each room is used.
- A written proposal that names the product, the glass, the installation method and who applies for the permit when one is needed.
- Final measurements, then the order.
- Installation, clean-up and a walk-through with you. The energy label stays on each window until any inspection is done.
Questions
Questions from Danville homeowners
Do I need a permit to replace windows in Danville, even same size?
Yes. The town requires a permit for any window replacement, including a same-size insert (Town of Danville handout, rev. 1/28/2026, checked 11/15/2026).
We live in Alamo. Is it the same rule?
The result is the same, from a different office: Alamo is unincorporated, so Contra Costa County issues the permit, and the county requires one for all window replacements, with a rough frame inspection before the stucco or siding is closed and a final (Contra Costa County, Residential Window Replacement Building Inspection Requirements, rev. Sep 2021, archived copy of 2/9/2025).
Can a big picture window be replaced as one piece?
Usually, yes, up to the size the glass and the frame are made in. Above that the opening is split with a slim frame member; we show you both on the measure.
How is a tall window above a stairway replaced?
We check access and the size of each pane at the visit and plan how it is reached safely.
What will it cost?
It depends on how many openings, their sizes, the frame material, the glass and the installation method. You get a written price after the in-home measure, before you decide anything.
Is there a tax credit or rebate for new windows in 2026?
The federal energy credit covered improvements made through December 31, 2025 (IRS), so windows installed in 2026 do not qualify. Neither PG&E nor SMUD lists a rebate for windows or doors today. More on our dated page: window tax credit and rebates in 2026.
Free in-home consultation
Book a free visit in Danville.
Tell us how many windows or doors, and your ZIP. Or call (844) 790-3600.
ZIP codes we serve in and around Danville: 94506, 94507, 94526, 94528.